...for about the fifth or sixth time.

I used a B23FT motor being stored on an engine stand as my mock up motor. It allowed me to fit and dimension the crank sensor bracket as I was constructing it.

This tec3 system is being installed on a B23FT.

In this pic, I am doing a semifinal check on the fitment and alignment and location and clearances of the bracket and sensor.

I hadn't added the reinforcement yet; and I wanted to make sure that I did have things dialed in before I added any more steel to the bracket. It was already rather hefty and solid. This was the time to make any final revisions and adjustments to the bracket.

Then the reinforcement could be welded on as a final thing.