|
|
|
|
|
|
|
| bartenderdave | profile | all galleries >> Surf Scoter: A Cuddy Cabin Bartender >> 20-4 Bartender Part III >> Coaming Rim | tree view | thumbnails | slideshow |
 Starboard, aft coaming rim, prepped for bedding of extrusion; Teak oarlock mount in place. |
 Oarlock mount detail -- locks about 15 inches aft of the front of the engine box. |
 Trex "extrusion" milled on table saw, planer and shaper, about 5/4 by 4/4; kerfing needed to make bends. |
 Extrusion dry fit, starboard side. Pedestal later removed. |
 This stuff takes tons of clamps, because of the kerfing: every 6 inches as a minumim separation. |
 And, tons of bedding to get good distribution; lots of squeezeout up top, but the legs needed a second pass. |
 Detail of a cleaned up section of the finished installation. Should I paint this or leave it "retro?" |
 Aft starboard extrusion, completed. |
 Last detail before initial sea trial (the sheer guard can wait): Stainless keel guard under the bow; more 4200 work. |
 HIN stenciled on coaming rim, and Dremeled in place. Strong side lighting brings out the HIN. |
 |
| comment | share |