![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
For the next step I needed to cut the openings for the NFM ports slightly bigger than the Beckson's had been and also accommodate for the spigot. I used the NFM Template (shown in the previous photo) which, as I said, is a must have item for this job.
To cut the openings I chose to use the NFM template as my router guide and use my Ryobi laminate trimmer with a bearing guided flush cut bit. Using a jig saw, hand saw or sanding drums just seemed like an awful lot of work!
This photo shows the template clamped to the inside of the cabin and a partial routed edge. Make sure you clamp tightly!
Full EXIF Info | |
Date/Time | 23-Apr-2008 12:55:16 |
Make | Nikon |
Model | NIKON D200 |
Flash Used | No |
Focal Length | 24 mm |
Exposure Time | 1/125 sec |
Aperture | f/5.6 |
ISO Equivalent | 100 |
Exposure Bias | |
White Balance | |
Metering Mode | matrix (5) |
JPEG Quality | |
Exposure Program | program (2) |
Focus Distance |
© All Images property of Compass Marine Inc.