|
|
|
|
|
|
|
| |
| 22-JAN-2009 | |
Once the shaft is cut to length it is then tested for run out. A good shafting shop should ALWAYS do this even with a brand new shaft. If it does not meet tolerance then it needs to be made true. This one was out by less than .001 for a 52" shaft.
This shaft was also checked for true after the machining process.
*******CLICK BELOW FOR PAGE 2*******
| Full EXIF Info | |
| Date/Time | 22-Jan-2009 14:51:43 |
| Make | Nikon |
| Model | NIKON D40 |
| Flash Used | No |
| Focal Length | 55 mm |
| Exposure Time | 1/59 sec |
| Aperture | f/9 |
| ISO Equivalent | 200 |
| Exposure Bias | |
| White Balance | |
| Metering Mode | |
| JPEG Quality | |
| Exposure Program | |
| Focus Distance | |
© All Images property of Compass Marine Inc.