15-Jul-2015
All skins attached
All of the flare skins are complete and ready to bolt onto the Jeep.
15-Jul-2015
Flares ready to go
I have a little work to do on the backing plate and mounts before I can install all of the flares.
17-Jul-2015
Repairing the crack
After welding the crack In my passenger side front fender I shot a little repair paint on it so that it wouldn't rust up.
Crack repair complete
After shooting a couple coats of clear and it's done!
19-Jul-2015
All of the flares mounted
After the paint dried on the flares, aluminum skins installed, all four flares mounted.
19-Jul-2015
Front flares
Front flares bolted up tight. Now I shouldn't have to worry about the fenders cracking from the stress of flexing.
19-Jul-2015
Another view of the front flare
This angle shows the large support flange.
19-Jul-2015
Rear flare
The rear flares still give good clearance even for when I move up to larger tires.
19-Jul-2015
Another view of the rear flare
The large flange offers good support even if bashed on rocks.
22-Jul-2015
Time to finish the inner door skins
I cut some aluminum pieces to fit in the center of the doors so that don't have the big opening in the door.
22-Jul-2015
Aluminum door cover
All drilled and ready to mount. I'm using some 10-32 nutserts in the door to fasten the aluminum to.
22-Jul-2015
A little sound deadening
I added some sound deadening material so that the doors don't sound so tinny when you slam them.