|
|
|
|
|
|
|
| Eldata | profile | all galleries >> D300 shots >> Miscellaneous >> Ryobi DP100 Treadmill motor conversion | tree view | thumbnails | slideshow |
 DP100 drill press |
 Treadmill control panel |
 Treadmill innards |
 MC-70 motor controller |
 Motor |
 Bench testing (1) |
 Bench testing (2) |
 Motor disassembled (1) |
 Motor disassembled (2) |
 Motor disassembled (3) |
 Milling (cutting) motor bracket |
 Motor shell with modded bracket |
 Motor with modded mounting bracket |
 Milling new motor base |
 New motor base setup |
 Rare-earth neodymium magnets |
 Drill press spindle drive sleeve with bearings |
 Head assembly prepped for milling |
 Head assembly prepped for drilling |
 Hand-tapping (1) |
 Hand-tapping (2) |
 Finger-tapping |
 Sensor and drive sleeve in place |
 Spindle pulley installed |
 Some items used for aluminum surface prep |
 Control panel support |
 Control panel (sans cover) prepped for bending |
 Control panel (sans cover) after bending (1) |
 Control panel (sans cover) after bending (2) |
 Confirm alignment and clearance capability (1) |
 Confirm alignment and clearance capability (2) |
 Confirm alignment and clearance capability (3) |
 Wired Control Panel (1) |
 Wired Control Panel (2) |
 Wired Control Panel (3) |
 Completed Control Panel (1) |
 Completed Control Panel (2) |
 Mains power routed through drill press base (1) |
 Mains power routed through drill press base (2) |
 Assembly prepped for control panel installation |
 Hole drilled in 1/4" steel angle (1) |
 Hole drilled in 1/4" steel angle (2) |
 Holes drilled in 1/4" steel angle |
| comment | share |