photo sharing and upload picture albums photo forums search pictures popular photos photography help login
Type your message and click Add Comment
It is best to login or register first but you may post as a guest.
Enter an optional name and contact email address. Name
Name Email
help private comment
Rolf | profile | all galleries >> Hot shoe adapter, DIY tree view | thumbnails | slideshow

Hot shoe adapter, DIY

An old 35mm camera with a hot shoe, available at a lot of junk stores for a dollar or so, is the foundation of this little project.
2mm phone plugs are used for the electrical connections.
I don't know what the 1/4" 20 nut is called.
Cut the plastic surrounding the hot shoe to about 1 3/8" wide, 1 1/8" deep and 1/2" high. Be careful not to rip the wires going to the hot shoe! Cut to about 1" and strip.
Carve a place for the female connector in one corner. Hot glue connector and nut in place. Solder wires, make sure center connector of hot shoe goes to the tip of phone plug. Use more hot glue to hold wires in place.
Use epoxy putty to encase it all, trim before epoxy hardens! Paint black.
Total time about one hour.
Total cost, less than $10.00.
Information on slave flash trigger used in picture on lower right: http://www.pbase.com/sinoline/pic_ii
Hot shoe adapter.
Hot shoe adapter.