Curtis Palmer's 84 Shelby Charger For Sale $3000/OBO
Due to our current state of economy putting financial strains on my life (and a certain lack of free time) I've decided to sell my 84 SC. The car is in mid conversion to a Weber DCOE/DOHC set-up and the top end of the engine (head) is currently not assembled/running. The bottom end has not been touched/modified to accept the DOHC head. The stock radiator support has been removed and replaced with a custom unit to fit a new, larger aluminum radiator and fan (included). The engine hasn't been modified to the point that it could not be undone and put back to stock by using a stock head and replacing the radiator support.
Lots of mods! Odometer showing 44,000 miles (144,000 miles) Engine completely rebuilt a few years ago using a turbo block, ARP studded main bearings, balanced and honed with a torque plate, Turbo rods, 10.5:1 compression, custom built intake manifold for dual Weber DCOE 45's, Holly "Red" electric fuel pump, MSD ignition with rev limiter, Mallory Unilite distributor, Koni adjustable shocks/struts with Ground Control coil-overs, custom built adjustable rear sway bar, CSX calipers/rotors with Porterfield pads in front, heim joint shift linkage with modified short shifter, Sparco seat, Grant steering wheel, Auto Power roll bar (not installed)...The list goes on and on. Repainted several years ago and garaged ever since. This car is a blast to drive! Also comes with a basement full of parts and pieces including a nice lower air dam, 2 doors, heads, headers... Located near Lancaster, PA. $3000/OBO 717-808-8129