The Top Cover is the first piece to put
back on to the camera. This can be a lesson
in frustration or at least make you wish you
had many hands.
The first thing that I did was to clean the
LCD Top Screen on the camera, then cleaned the
inside glass of the top cover. Handle with care
after this cleaning "No Fingerprints Allowed".
Then it is time to re-attach the ribbon cable to its
connector keeping in mind the routing for the cable.
Then tilt/wiggle the cover and at this time open the Flash
Door and feed the Top Cover tab thru the opening, so
that the tab and screw align inside the flash compartment.
Handle with care, keep in mind that you do not want to break
the ribbon cable or disconnect it. Again keep your fingers
off the LCD and the glass. This is the hardest part of the
whole assembly, but take your time and you will get there.