Tubular tie-rods and bumpsteer pins installed photo

Zack Barnes | all galleries >> Galleries >> My DP MR2 > Tubular tie-rods and bumpsteer pins installed


13-NOV-2010

Tubular tie-rods and bumpsteer pins installed

For 85-86 MKI MR2s the 11-12" threaded aluminum body is needed.
For 87-89 MKI MR2s the 9-10" threaded aluminum body is needed

Cantilever slicks - note the proximty of the tire/lower portion of the pin - first event did not show contact between the tire and the pin. Yes, cantivlever slicks deform that much under cornering.

Sony DSC-W1
1/8s f/3.5 at 12.1mm iso320 full exif

other sizes: small medium large original auto

previous | next

Type your message and click Add Comment

It is best to login or register first but you may post as a guest. Enter an optional name and contact email address. Name
Name Email
help	private comment

Type your message and click Add Comment

It is best to login or register first but you may post as a guest. Enter an optional name and contact email address. Name
Name Email
help	private comment