photo sharing and upload picture albums photo forums search pictures popular photos photography help login
Mark Lerman | all galleries >> Direct PCB Printing with a Laser Printer > 3mil_laminator.jpg
previous | next
3mil_laminator.jpg

3mil_laminator.jpg

This is the fully etched board. I used a laminator to seal the toner to the board after a quick ride in the oven to "set" the toner. See the previous scan for details concerning the bits of copper floating on the board. The laminator makes all the difference in preventing the "pocked" effects seen in my earlier attempts. Note again that these are 3 mil traces.


other sizes: small medium large original
share
Type your message and click Add Comment
It is best to login or register first but you may post as a guest.
Enter an optional name and contact email address. Name
Name Email
help private comment