photo sharing and upload picture albums photo forums search pictures popular photos photography help login
Compass Marine How To | all galleries >> Compass Marine How To Articles >> Sealing Deck Penetrations to Prevent Core Rot > Brad Point Drill
previous | next
Brad Point Drill
04-Nov-2006

Brad Point Drill

When drilling into fiberglass the proper tool is a must. This is a brad point drill and it will create a clean, no chip hole in gelcoat provided you use a few tricks.


The main trick is to always start the drill in reverse! This trick also works well with hole saws. By starting in reverse it allows the outer cutting edges of the drill to cut cleanly through the gelcoat. Once through the gelcoat you can then switch the drill to forward and complete the hole without chipping any gelcoat off the surface.

Nikon D200
1/60s f/3.5 at 70.0mm iso100 hide exif
Full EXIF Info
Date/Time04-Nov-2008 11:34:34
MakeNikon
ModelNIKON D200
Flash UsedNo
Focal Length70 mm
Exposure Time1/60 sec
Aperturef/3.5
ISO Equivalent100
Exposure Bias
White Balance
Metering Modematrix (5)
JPEG Quality
Exposure Programaperture priority (3)
Focus Distance

other sizes: small medium large
comment | share
Guest 18-May-2010 15:44
All these years of gelcoat chips and I'll I had to do was reverse the drill! None of the boat repair books ever mentioned this tip.
Bruce 22-Nov-2008 18:01
Great tip! I would have never thought to run the drill backwards. I will try it on my next project.