photo sharing and upload picture albums photo forums search pictures popular photos photography help login
Type your message and click Add Comment
It is best to login or register first but you may post as a guest.
Enter an optional name and contact email address. Name
Name Email
help private comment
Compass Marine How To | all galleries >> Welcome To >> Replacing A Fuel Tank > Pinhole
previous | next


This tank bottom is vee-shaped thus any debris or crud winds up in the vee. The tank bed was very well designed and the vee is suspended in air on all sides so no moisture was in contact with the tank.

When we cut the tank open I sifted thought the dead organisms and found a chunk of dissimilar metal right over the hole. It seemed to possibly be a piece of stainless steel that had somehow fallen into the tank somewhere along the way, possibly during a sending unit change out?

I suspect that this piece of errant metal was the cause of the pin hole. There were no other signs of corrosion despite this being a 31 year old aluminum tank. Canadian Sailcraft did a very good job designing & engineering the fuel tank & beds.

Panasonic Lumix DMC-ZS3
1/100s f/3.3 at 4.1mm iso80 full exif

other sizes: small medium large
previous | next
comment | share
peter 18-Jun-2013 17:20
can anyone please describe to me how the pick up tube in this vintage (mine 1982 CS 36) is set up?

material? metal? plastic? open at end? screen? etc. i am experiencing random blockage and partial blockage before the racor. vacuum guage climbs gradually until the engine stalls. the engine will restart after short rest or blowing backwards through the fuel supply line by mouth. yum.