photo sharing and upload picture albums photo forums search pictures popular photos photography help login
Type your message and click Add Comment
It is best to login or register first but you may post as a guest.
Enter an optional name and contact email address. Name
Name Email
help private comment
Compass Marine How To | all galleries >> Compass Marine How To Articles >> Replacing A Cutlass Bearing (Sleeve Bearing) > Install Bearing
previous | next
Install Bearing
23-APR-2009

Install Bearing

Installing the bearing is actually quite easy. It requires some threaded rod, use at least 1/2", about four nuts, and some large and thick washers.


The most difficult part is actually getting the bearing started. You want it to go in perfectly straight so care must be taken to get it perfectly straight before beginning to tighten the threaded rod. If it goes in crooked it will bind and yo can ruin the bearing.


You may want to lube the inside of the strut and the outside of the cutlass with regular Ivory soap in bar form. Once the soap gets wet it dissipates and unlike grease or other lubes will not compromise the press fit of the bearing in the strut.

Nikon D200
1/60s f/5.0 at 22.0mm iso500 full exif

other sizes: small medium large
comment | share
Don Keenan 04-Oct-2013 07:22
I use a similar homemade tool to press bearing cups for headsets on a bicycle .
Same issues in starting straight. I use rubber stopper with center drilled hole to align the rod.
Rod, washers, and nuts the same. Cheap and works.