photo sharing and upload picture albums photo forums search pictures popular photos photography help login
Type your message and click Add Comment
It is best to login or register first but you may post as a guest.
Enter an optional name and contact email address. Name
Name Email
help private comment
Compass Marine How To | all galleries >> Compass Marine How To Articles >> Seacock Backing Plates / Alternate Method / No Through Bolts > Clamp & Drill
previous | next
Clamp & Drill
09-APR-2009

Clamp & Drill

This is the most critical step and why you really should have a drill press. Because you are literally drilling and tapping a piece of 5/8" fiberglass or epoxy sheet, the threaded holes MUST be perfectly centered in the flange holes, and they must be 100% vertical.


I made my spacer square, and wider than the head of the thru-hull, so I was able to clamp it in my drill press vice. I can not stress enough how important it is to make perfectly vertical holes that are perfectly centered in the holes of the flange or seacock. There is NO wiggle room here. Mess this up and you just wrecked the backing block..

Nikon D200
1/60s f/5.0 at 30.0mm iso200 full exif

other sizes: small medium large
comment | share