photo sharing and upload picture albums photo forums search pictures popular photos photography help login
Compass Marine How To | all galleries >> Compass Marine How To Articles >> Rebuilding A Raw Water Pump > How Did It Get So Clean ?
previous | next
How Did It Get So Clean ?

How Did It Get So Clean ?

I know some will wonder how this pump went from that grungy old pump look to shiny & new looking. It's easy, I use a brass wheel on my bench grinder and burgundy colored Scotch-Brite discs on my Dremel. I clean the cover plate and pump gasket surfaces with wet sand paper and honing oil on a piece of 3/8" thick glass for a smooth surface.

Nikon D40
1/60s f/4.5 at 31.0mm iso200 full exif

other sizes: small medium large
comment | share
Dave Main 23-May-2011 01:31
Is it recommended/instructed to clean the pump to the state pictured below before the re-build?
Jim 15-Oct-2010 20:21
Don't use the Scotchbrite wheel on the flat machined surface that the cover gasket goes on. You will make it look clean, but may damage the flatness and cause it to leak. A better way to clean that surface is use a file and hold it flat on the gasket surface while moving it, being careful to keep it flat and even.