photo sharing and upload picture albums photo forums search pictures popular photos photography help login
Type your message and click Add Comment
It is best to login or register first but you may post as a guest.
Enter an optional name and contact email address. Name
Name Email
help private comment
Compass Marine How To | all galleries >> Welcome To >> Engine Temp Monitoring & Over Heating Baseline Assessment > Measuring the Thermostat Housing
previous | next
Measuring the Thermostat Housing

Measuring the Thermostat Housing

In this photo I'm measuring the temperature of the upper thermostat housing.

I know the red laser dot is off slightly from my dot but holding the DSLR camera, with a hot shoe flash, and the infrared while upside down and contorted leaves it up to "close as it gets".

The petcock mounted to the top of this housing is where you would bleed any trapped air off the sealed or anti-freeze side of the system to prevent an air lock. Some engines have this feature & some don't. On some engines this petcock is just in a different location.

*WARNING: Before attempting a bleed a petcock moisten a rag with COLD water so you don't burn your fingers and wear insulated fishing gloves made of rubber. The antifreeze can burn you if you are not careful. I recommend a cold rag over the petcock, rather than pliers because it can spray out at a high force. Trust me, you don't want to use just pliers with no rag to prevent spray while upside down and contorted. Ouch!

Nikon D40
1/60s f/4.0 at 24.0mm iso200 full exif

other sizes: small medium large
comment | share