|
|
|
|
|
|
|
| fred harmon | profile | all galleries >> concours14 >> nep | tree view | thumbnails | slideshow |
 NEP CC-3 Throttle Lock |
 I used a dremel to remove the ridges off the bottom piece |
 I then flipped the bottom piece over and reinstalled it, so that the tab was at the lowest point |
 I drilled a 1/4 inch hole in it for the screw on the throttle housing |
 Make sure to put it on an mark the position of the hole before you drill it, so it lines up |
 Remove screw on bottom of throttle cables |
 Pull back grip, install throttle lock |
 Put the tab between the housing and braket |
 Tab in place |
 Reinstall screw |
 Roll the grip back on and you are done. Check for freedom of movement and adjust as needed |