Interface setup_2009 to capture insects in-flight. This interface connect most of the elements to the hardware CPLD module ( the Terasic MAX II board). All the signals are driven from this CPLD board via the max_con1 and the max_con2 connectors. The previous AVR controller are also connected to this board. Outputs are available for the D200 camera, the 3x flash SB800 or SB-80-DX, the 2x16 char LCD display, the 2 IR lasers, the 2 green lasers, the high power leds, the switchs and the push buttons. Power regulators for the lasers can set to the correct voltage. This hole module is placed into the frame below the macro lens.